Cupcake Stand Tutorial

Hope asked me how I made my cupcake stands...so I wrote a tutorial & drew some pictures. I will repost again with actual photos to make it easier to follow. For now here it is:

Cupcake Stand Instructions (holds 48-120 cupcakes)

Supplies:
  3 foam core boards, ¼” thick Dimensions: 20” x 30” (available at Staples or Michaels)
  Exacto knife
  Ruler
  Hot glue gun
  Modge Podge adhesive
  Paper (wrapping paper or ten pieces of 12 x 12 scrapbook paper)
  Ribbon (5 yards)

foam board & Modge Podge

1. Make your cuts…
    a.) Foam board piece 1
         cut a square 20” x 20” = Tier 1
         cut a square 8” x 8” = Tier 4
    b.) Foam board piece 2
         cut a square 16” x 16” = Tier 2
         cut a square 12” x 12” = Tier 3

2. Cut your tier supports…using Foam board piece 3
    a.) for tier 1…cut 4 strips 2” high x 10” long
    b.) for tier 2…cut 4 strips 4” high x 8” long
    c.) for tier 3…cut 4 strips 4” high x 6” long
    d.) for tier 4…cut 4 strips 4” high x 4” long

3. Cover all of your Tiers with paper using Modge Podge adhesive. If you are using 12 x 12 scrapbook  
    paper, tiers 1 & 2 can be tricky. Cut 2 pieces of 12” x 12” scrapbook paper in half diagonal (see photo
    below). Then use the  4 pieces and glue it on the board. Trim edges with an exacto knife.

4. While your tiers dry make your tier supports. Starting with the “foot” of the stand, glue the corners of the

    2” x 10” together. Continue by gluing the rest of the tier supports together so they are all square.
5. Cover the tier supports with paper.

6. Hot glue ribbon to the edges of each tier. It’s easier to do this prior to gluing the tiers to the tier supports.

7. The hardest part here is making sure the tiers & supports are centered.
    Hot glue the 2” x 10” tier support to the bottom side of the 20” x 20” tier.
    Hot glue the 4” x 8” tier support to the bottom side of the 16” x 16” tier.
    Hot glue the 4” x 6” tier support to the bottom side of the 12” x 12” tier.
    Hot glue the 4” x 4” tier support to the bottom side of the 8” x 8” tier.

8. Glue the 8” x 8” to the top of the 12” x 12”.  Glue the the 16” x 16” to the top of the 20” x 20”.
    Glue the two pieces together & you have your cupcake stand.